Kodiak Black Bush Honeysuckle

Planting & Care for Deciduous Shrub – Bush Honeysuckle

Preparation

• This plant works extremely well for mass planting and sloping areas in your landscape.
• Can be planted in sandy and dry soil areas.
• Plus, it will tolerate heavy soils!
• Added bonus, this is a low maintenance plant that is pest free.
• Mature growth is around 3-4' tall and wide.
• They like full sun or partial shade.
• They prefer well-drained soils that are humus-rich, sandy loam, or clay loam.

Opening Plant Material

• Bare Root - Cut open the bundle (top and roots are tied) and separate all the plants. Soak roots in buckets of water until planted. Each plant type will be labeled separately for identification. Do not expose the roots to sun. They should never dry out. Keep roots covered. All bare-root plants must be trimmed when planted. 
• Containers - Completely saturate all container plants by putting in a larger container of water until stops bubbling, remove. Now ready to plant. Dig a hole no deeper than the depth of the container and 6" or more, making sure it’s wider on the sides.

Planting Bare Root

• Plant Bare root in fall. A good indicator if you can still plant is if the ground is still workable you’re good to go. If a hard frost is expected be sure to hold off on planting.
• Dig a hole at least 6" wider and the same depth as the root mass. The crown or graft of the plant should be slightly higher than ground level where it was grown at the nursery.
• Trim off the broken roots and branches.
• Place fertilizer packets in hole (if purchased). Do not place other fertilizers in the planting hole. *Use Our Recommended Fertilizer.
• Spread the roots and fill halfway with soil, then water until soil settles completely saturating the soil and planting pit.
• Re-adjust plant and fill the hole with the rest of the soil.
• Back fill the balance of the soil and water well. 
• See our link below “Handling & Planting Guidelines” for illustrations on planting.   

Planting containers

• Slide plant from pot by tapping on the bottom of the pot.
• With shovel or knife trim bottom 2" off of the root ball for plants in plastic containers.
• Rotate the plant to the proper position. Never lift or move plants by the tops.
• Place the root ball in the hole.
• Notice where the base of the trunk flairs out from the tree. This is called the root flair. This root flair should show when the tree is planted. If necessary, add soil under the ball so the root flair is exposed.
• Place fertilizer packets into the bottom of the hole (if purchased). *Use Our Recommended Fertilizer.
• Backfill the hole with soil, making sure the top of the root ball is visible and slightly higher than the soil around it.
• Firm the soil around the plant. Water well to settle soil around the root ball.

Pruning - After Planting

• Bare Root - Prune ALL bare root plants to reduce transplant shock and ensure success. Pruning should occur either before or as soon after planting as possible. All pruning should be done with a sharp pruning shears.
• Containers - Although it is not essential for containers to be pruned after planting, a light pruning for shape, to remove any broken branches from shipping, or to thin out a heavily branched plant will help in the transplanting process and in the appearance of your new planting.

Pruning - Through-out the Season

• Keep in mind that it easily rejuvenates by cutting to the ground in spring when needed.

Watering - After Planting

• Plants typically take approximately 6 weeks to establish new roots in your soil. During this period, water plants as often as every 2-4 days at the start and at least a minimum of once per week.
• Beyond the 6 week establishment period, water once per week, unless rains occur.
• Stick your finger into the soil around 3” to check soil moisture.

Watering - Through-out the Season

• After the first season, plants should only be watered during extended periods without rain.
• How do you know if your plants need water? The easiest way to tell is to touch the soil around the roots. If it is moist, there is no need to water. If it is dry, give it a good soaking with the hose end (no nozzle) watering the soil only, not the leaves.
• Stick your finger into the soil around 3” to check soil moisture.

Go to our "Plant Features & Video Tab" for more information & tips on caring and maintaining this plant.